What’s going on in the world of thermal energy storage?

Share

From pv magazine US

Siemens Energy and EnergyNest have entered into a long-term partnership to develop thermal energy storage solutions for industrial customers. The two companies are exploring the use of excess renewable electricity to charge a thermal battery, which would in turn release steam when needed to provide power — lowering the plant’s natural gas demand, while increasing flexibility.

Life as niche tech

Thermal storage has long been considered vital to decarbonization, yet the market for the technology has remained niche and expensive. This is a reality recognized by Siemens and EnergyNest, with the two companies laying out their intent to create modularized and standardized thermal storage systems — improving both the efficiency and economics of the technology into a scalable model.

Thermal storage is currently a $4.35 billion market, small potatoes in the energy world. And while the technology is currently held back by limited efficiency and even more limited project economics, proponents of the technology hold to the idea that thermal storage can offer higher power capacity, improved cycle life and better overall system reliability, in comparison to lithium-ion batteries.

Siemens and EnergyNest aren’t the only companies operating in the thermal storage sector, so what other innovations are being made to guide this niche technology into the mainstream?

Development stage

It’s not just private companies looking to expand the scope of thermal storage. The National Renewable Energy Laboratory (NREL) has launched a project aimed at increasing the efficiency of thermal storage to then use the energy to  drive a turbine-generator set. Specifically, NREL is looking to develop a system that uses electricity to power a high-performance heat exchanger, which will heat inexpensive solid particles to over 1100°C. The particles will be stored in insulated silos for up to several days. When electricity is desired, the hot particles will be fed through a fluidized bed heat exchanger, heating a working fluid to drive a Brayton combined-cycle turbine attached to a generator.

Speaking of Brayton Energy, the company is currently developing what it calls a “key component” to integrate turbomachinery into a cost-competitive thermal energy storage system. In English, that means that Brayton is looking to create a system in which each turbomachinery stage is designed to act as both a compressor and turbine, alternating between charging and discharging cycles. This system simplification and consolidation of parts is expected to increase efficiency and reduce capital costs.

In 2018, Echogen began development of an energy storage system that, according to the company, uses a CO2 heat pump cycle to convert electrical energy to thermal energy by heating a “reservoir” of low cost materials such as sand or concrete. The reservoir then retains the heat, which will be converted back into electricity on demand. To generate power, liquid CO2 will be pumped through the high-temperature reservoir to a supercritical state, after which it will expand through a turbine to generate electricity from the stored heat.

These three development projects are being carried under a quasi-competing series of grants given out by ARPA-E, in pursuit of getting long-duration storage costs down to 5 cents per kWh. The grants include more than just thermal storage, and have been covered previously by pv magazine.

While development and research interest in thermal storage is quite easy to come by, commercial projects and fully-realized solutions are another matter entirely.

Azelio

Swedish start-up Azelio — which stores energy in molten aluminum — has made the breakthrough into commercial molten-storage projects. One of the company’s storage solutions has been installed alongside the 580 MW Noor Ouarzazate solar complex (510 MW of CSP and 70 MW of PV), in Morocco. Azelio’s technology uses electricity to heat recycled aluminum to 600°C. When power is required from the storage unit, the stored thermal energy is transported to a Stirling engine using a heat-transfer fluid.

Just this past week, the company signed a memorandum of understanding with US-based Trimark Associates, for more than 45 MW capacity of Azelio’s energy storage until 2025, with Trimark serving as system integrator, in an attempt for Azelio to get a foothold in the American market. The first projects are targeting 150 kW in 2021, followed by 3 MW in 2022, 6 MW in 2023, 12 MW in 2024, and 24 MW in 2025.

1414 Degrees

Headquartered out of Adelaide, Australia, 1414 Degrees is a molten silicon thermal storage company looking to deliver thermal storage solutions for customers with needs ranging from 10 MWh to 1 GWh. The silicon is stored at 1414 degrees, hence the name. The company made waves at the end of 2019 after purchasing the company SolarReserve Australia II Pty Ltd, which owns the Aurora Solar Energy Project near Port Augusta in South Australia. This project is a 220 MW combination of 70 MW of PV and 150 MW of concentrated solar power that 1414 Degrees is seeking permission to expand by adding 400 MW of PV.

The company intends to use the Aurora project to pilot its TESS-GRID thermal storage technology and deliver stable power to the grid.

Alumina

Alumina is a California-based company which has developed a storage technology that uses a high temperature stable ceramic storage material with high thermal conductivity, heat capacity, and low cost to store and recover thermal energy or heat, up to 1,500 °C. While the company hasn’t been able to apply its technology to any large-scale projects yet, it recently signed a memorandum of understanding with UAE-based Seramic Materials to explore the introduction of recycled ceramic materials in packed bed thermal energy storage. Seramic Materials has developed a solution to recycle industrial solid waste into sustainable ceramic products.

By Tim Sylvia

This content is protected by copyright and may not be reused. If you want to cooperate with us and would like to reuse some of our content, please contact: editors@pv-magazine.com.

<

Share

Related content

Elsewhere on pv magazine...

Leave a Reply

Please be mindful of our community standards.

Your email address will not be published. Required fields are marked *

By submitting this form you agree to pv magazine using your data for the purposes of publishing your comment.

Your personal data will only be disclosed or otherwise transmitted to third parties for the purposes of spam filtering or if this is necessary for technical maintenance of the website. Any other transfer to third parties will not take place unless this is justified on the basis of applicable data protection regulations or if pv magazine is legally obliged to do so.

You may revoke this consent at any time with effect for the future, in which case your personal data will be deleted immediately. Otherwise, your data will be deleted if pv magazine has processed your request or the purpose of data storage is fulfilled.

Further information on data privacy can be found in our Data Protection Policy.

This website uses cookies to anonymously count visitor numbers. To find out more, please see our Data Protection Policy.

The cookie settings on this website are set to "allow cookies" to give you the best browsing experience possible. If you continue to use this website without changing your cookie settings or you click "Accept" below then you are consenting to this.

Close